Looking for Samsung washer repair near you in Toronto? Call (437) 524-1053 — we dispatch a certified technician from your local area, available 7 days a week. Same-day service, and we've served the GTA since 2017.
Quick Answer: Samsung washers display error codes that pinpoint the failing system. Some codes clear with a reset; others require a certified technician. This guide covers every major code and what action to take in Toronto.
Samsung Washer Error Codes: Complete Reference Guide for Toronto
Samsung front-load and top-load washers use alphanumeric error codes to communicate faults. Here's what each code means and whether it's a DIY fix or a call-a-tech situation:
4E / 4C — Water Supply Error
The washer is not receiving enough water. Check that both hot and cold water taps are fully open and that the inlet hoses aren't kinked. Also check the inlet filter screens at the back of the machine — these can clog with debris. If the screens are clear and water supply is confirmed, the water inlet valve has likely failed. Repair cost: $150–$240 CAD.
5E / SE — Drainage Error
The washer cannot drain. Start by cleaning the drain filter (accessed via the small panel at the front bottom of the machine). Clear any lint, coins, or debris. If the 5E code persists after cleaning, the drain pump motor has failed. Repair cost: $150–$240 CAD.
UE / U6 — Unbalanced Load
The drum detected an unbalanced load during the spin cycle. Open the door, redistribute the laundry more evenly, and restart the spin. If UE appears on every cycle regardless of load balance, the suspension rods (top-load) or shock absorbers (front-load) are worn. Repair cost: $160–$270 CAD.
DC — Unbalance During Spin
Similar to UE but specific to front-load models. On first occurrence, redistribute the load. Recurring DC codes point to worn shock absorbers. Repair cost: $160–$270 CAD.
Sud / SD — Excess Suds
Too much detergent or non-HE detergent was used. The cycle will pause until suds reduce. Switch to HE (High Efficiency) detergent and use the correct amount. If Sud appears even with HE detergent at correct dosage, the pressure switch or control board may be triggering a false positive. Repair cost: $140–$250 CAD.
E3 / 3E — Motor Error
The drive motor or motor control board has a fault. This typically requires component-level diagnosis. The motor hall sensor is a common failure point on Samsung units. Repair cost: $200–$340 CAD.
OE / 0E — Overflow
Water in the drum has exceeded the maximum level. This is caused by a faulty water inlet valve that doesn't close properly, or a failed pressure sensor. Repair cost: $150–$250 CAD.
What to Do When Your Samsung Washer Shows an Error Code Near Toronto
Note the Error Code
Write down the exact code displayed. If it disappears quickly, it may still be stored in the washer's diagnostics, which our technician can retrieve.
Try a Power Reset
Unplug the washer from the wall outlet for 2 full minutes, then plug it back in. Some error codes (especially UE, Sud) clear after a reset.
Check the Filter and Hoses
For 5E/4E codes specifically, check the drain filter and inlet screens before calling. These are owner-accessible checks that may resolve the issue.
Call Us If the Code Returns
If the error returns after a reset, a mechanical or electrical fault exists. Call (437) 524-1053 for same-day Samsung washer repair near you.
Samsung Washer Repair Costs Near Toronto 2026
- Water inlet valve (4E/4C): $150–$240 CAD
- Drain pump (5E/SE): $150–$240 CAD
- Shock absorbers / suspension (UE/DC): $160–$270 CAD
- Pressure switch (OE/Sud): $140–$230 CAD
- Drive motor / hall sensor (3E): $200–$340 CAD
- Control board: $220–$360 CAD
Pro Tip: Samsung washers record recent error codes in their internal memory. A trained technician can enter diagnostic mode (typically by holding a button combination) to read stored codes — even ones that cleared themselves. This is far more accurate than guessing from symptoms alone.
Need Samsung Washer Repair Near You in Toronto?
Same-day local dispatch available. We carry parts. 90-day warranty on all repairs.